Luverne 330750 Installation Instructions

LUVERNE GRILL GUARDS WITH THE FOLLOWING MODEL NOs.:
2007 AND NEWER TOYOTA TUNDRA SERIES TRUCKS
1. READ THE INSTRUCTIONS COMPLETELY AND CHECK TO MAKE SURE THAT ALL OF THE
REQUIRED PARTS ARE ON HAND BEFORE STARTING THE INSTALLATION. THE CARTON
SHOULD CONTAIN:
(1) OUTER RING PACKAGE
(1) OUTER RING ASSEMBLY
(1)UPRIGHT PACKAGE
(1) UPRIGHT ASSEMBLY, RH
(1) UPRIGHT ASSEMBLY, LH
(1) MOUNTING BRACKET, RH
(1) MOUNTING BRACKET, LH
(1) MOUNTING BRACKET, RH, TOP
(1) MOUNTING BRACKET, LH, TOP
(2) UPRIGHT COVERS (CHROME GUARDS ONLY)
(1) HARDWARE PACKAGE
(1) CUSTOMER SERVICE PACKAGE
GUARD ASSEMBLY & INSTALLATION INSTRUCTIONS 2-11
2. LOOSEN AND REMOVE THE TWO BOLTS IN THE BOTTOM OF THE RIGHT HAND FRAME RAIL,
THAT SECURE THE TOW HOOK TO THE FRAME.
3. SPIN A 1/2"-13 SERRATED FLANGE NUT (ITEM #13) ALL THE WAY ONTO THE THREADED END
OF THE TOP RH MOUNTING BRACKET (ITEM #6), AS SHOWN IN fig. 1. REMOVE THE TOP TWO
NUTS OF THE BOLTS THAT ATTACH THE END FRAME HORN TO THE END OF THE MAIN FRAME.
INSERT THE BRACKET END OF THE BRACKET THROUGH THE OUTSIDE HOLE IN THE FACE OF
BUMPER AND INSTALL TWO M10 X 1.25 FLANGE NUTS (ITEM #22).
4. INSTALL THE RIGHT HAND MOUNTING BRACKET (ITEM #4), (NOTE: INSERT THE THREADED
END OF THE TOP MOUNTING BRACKET THROUGH THE TOP HOLE IN THE BACK OF THE
BOTTOM MOUNTING BRACKET AND INSTALL A 1/2"-13 SERRATED FLANGE NUT (ITEM #13)
BEFORE ATTACHING THE BOTTOM BRACKET TO THE FRAME.) USING THE TWO M12 X 1.25
X 45mm BOLTS (ITEM #16), TWO 1/2" LOCK WASHERS (ITEM #17) AND TWO 7/16" FLAT
WASHERS (ITEM #19) REINSTALL THE TOW HOOK AS SHOWN IN fig. 1, 2 & 3. HAND TIGHTEN
ONLY AT THIS TIME.
5. REPEAT STEPS 2 & 3 FOR THE LEFT HAND SIDE.
INSTALLATION INSTRUCTIONS
FOR MOUNTING
330750/330753 & 340750/340753 ON:
REVISED 31MAR11 LVL A
202412 SHEET 1 OF 5 13APR07