Assembly Instructions - Oneida Air Systems V1500 Owner's Manual

Assembly Instructions

Before you start, determine which direction you want your filter to hang and which direction
you want your duct work to enter the collector. The fan housing and cyclone barrel bolt holes
are drilled at 45 degree increments; Some orientations are not possible.
Tip:
e collector will seem quieter if the outlet is aimed away from primary work area.
CORRECT
To assemble the supplied support system (e.g.
1
stand [FIG 1a] or wall-bracket [FIG 1b] refer
to the included instruction sheets:
• Stand Instruction Sheet # ZBI000018
• Leg Extension Instruction Sheet #
ZBI000013
• Wall Bracket Instruction Sheet and
Template # ZBI010018A and ZBT010018
10 Oneida Air Systems
INLET
INLET
CORRECT
INLET
FIG. 1a
INCORRECT
Filter will
obstruct
inlet pipe
FIG. 1b