Shoulder Strap - Makita SC103D Instruction Manual

Cordless threaded rod cutter
Hide thumbs Also See for SC103D:
Table of Contents

Advertisement

Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1 . Hex wrench

Shoulder strap

Optional accessory
Shoulder strap is useful for carrying the tool.
3
2
► 1 . Shoulder strap 2. Belt end 3. Buckle
CAUTION:
Always wear the shoulder strap
crossed over your body and adjusted in proper length.
CAUTION:
Do not use the shoulder strap if it
is damaged.
CAUTION:
Leave an sufficient length between
the buckle and belt end to prevent the belt end
from slipping through the buckle.
1
3
2
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing the cutting dies
CAUTION:
the correct directions and secured firmly. Incorrect
or loose attachment may cause breakage of the cutting
die, resulting personal injury by flown off fractions.
NOTICE:
Remove the burr on the cutting dies
using a file if any.
1.
Check if the jaw of the cutting die is fully opened. If not, install
the battery and pull the switch trigger until the jaw is fully opened.
CAUTION:
cartridge if you installed.
2.
Set the reversing switch lever to the lock position.
► 1 . Reversing switch lever
3.
Unscrew the bolts with the supplied hex wrench.
1
CAUTION:
with the tool. Using other wrenches may result in overtight-
ening or insufficient tightening which causes personal injury.
4.
Set the cutting dies onto the mounts so that the
two colored markings can be seen.
2
5
6
► 1 . Bolt 2. Cutting die 3. Stationary mount 4. Movable
mount 5. Colored marking 6. Hex wrench
10 ENGLISH
Always be sure that the tool is
Always install the cutting dies in
Be sure to remove the battery
1
Use only the Makita wrench provided
1
3
4
1
2

Advertisement

Table of Contents
loading

Table of Contents