Advertisement
Quick Links
INSTALL GUIDE
Covers All KEU-300 Series Advanced Factory
Keyless Upgrade Security Systems
www.ultrastarters.com
Technical Support: 866-698-5872 ext 0
support@ultrastarters.com
FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance
void the user's authority to operate this devise.
Advertisement
Related Manuals for Ultra Start KEU-300 Series
Summary of Contents for Ultra Start KEU-300 Series
- Page 1 INSTALL GUIDE Covers All KEU-300 Series Advanced Factory Keyless Upgrade Security Systems www.ultrastarters.com Technical Support: 866-698-5872 ext 0 support@ultrastarters.com FCC/ID Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 2 INSTALL MANUAL PAGE 2 Starter Disable Relay Starter Disable Relay Ground When Armed Ignition Input Ground Input 12volt Constant Input Horn/ Siren Input Horn/ Siren Output Flashing Park Light Output Second Channel Output Domelight/ Lock Output Positive Door Input Negative Door Input Hood/ Trunk/ Sensor Input Door Lock Wire Input Door Unlock Wire Input...
- Page 3 INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 3 12 pin Main Harness Red- +12volt Power Source Input. Connect this wire to a +12 VDC constant power source. To Battery or Ignition Harness. Black- System Ground Input. Connect this wire to chassis ground. To a clean unpainted metal surface. Yellow- Switched ignition input.
- Page 4 INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 4 12 Pin Connector...Continued Purple- Positive Door Pin Input. Connect this wire to vehicles that have a door pin that switches to 12 volts when the door is opened. Green- Negative Door Pin Input. Connect this wire to vehicles that have a door pin that switches to Negative when the door is opened.
- Page 5 REMOTE VEHICLE SECURITY 3 Pin Connector Continued Yellow- Unlock Switch Sense Input Mode. This input is designed to prevent the switch from disarming the alarm system. Connect this wire to the Unlock wire that is activated with the unlock switch in the door but not by the factory remote.
- Page 6 INSTALL MANUAL PAGE 6 DIP Switch Settings The DIP switches on the module are used to turn programmable features ON and OFF. The following are the features that are controlled by the DIP switches. Switch #1 ON= Passive Arming OFF= Active Arming In Passive Arming Mode the alarm will automatically arm 30 seconds after the last door is closed (Door pin connection required) In Active Arming Mode the alarm will only activate when the lock button is...
- Page 7 INSTALL MANUAL REMOTE VEHICLE SECURITY PAGE 7 System Programming The following features are programmed using the ignition switch and the LED/ Program Switch. To Enter Program Mode 1) Turn the ignition key “ON/OFF”, “ON/OFF” “ON” Leaving the key in the ON position.
- Page 8 INSTALL MANUAL PAGE 8 Setting #3- Park Light Output Turn the ignition key “ON/OFF”, “ON/OFF” “ON”, press and release the program switch 3 times. The LED will flash Three times to confirm setting Three. Hold the program switch until the siren chirps the appropriate number of times.