HDMI output to a display. This switcher can be controlled via the supplied remote control or by using the input switching button on the front of the device. The EL-C61C also features a CEC command function allowing the device to Auto-Switch on source power up.
• 6 by 1 HDMI v1.3 Switcher • Remote Control (CR-63 with battery) • 5V DC Power Supply Adaptor • Operation Manual. 4. Operation Controls and Functions 4.1 Front Panel EL-C61C 6x1 HDMI v1.3 Switcher xvYCC HD Audio Deep Color...
4.2 Rear Panel RS-232 DC 5V HDMI IN HDMI OUT 1. HDMI OUT: This is the slot where you connect the HDMI output of the switcher to the HDMI input of your display using a HDMI cable. 2. RS-232 input: When doing firmware upgrade and/or PC remote system control, connect a D-sub 9 pin cable from this RS232 slot to your computer.
4.3 Remote Control ② POWER ① ③ INPUT CR-63 1. Power: Press the button to turn on the unit-or set the device to standby mode. 2. CEC: Press the button to turn on /Bypass the CEC function. When the LED illuminate it means CEC is ON and both input source and output display must support CEC function in order to perform CEC rightly.
5. RS232 Pinouts EL-C61C Remote Control Console Definition Definition RS-232 transmission format: • Baud Rate: 19200 bps • Data bit: 8 Bits • Parity: None • Stop Bit: 1 bit • Flow Control: None 6. Command Sets COMMAND CODE Comment PORT 1 ON PORT 1 ...
Page 8
CEC ON CEC 1 CEC OFF CEC 0 REPORT STATE ST Note: 1. The command is a combination of characters and digits. 2. This combination command code has to be separated by ASCII character SPACE. 3. If the command is legal the unit will reply “OK” message . 4.
8. Specifications HDMI Input Port 6 x HDMI female ports + 1 x RS-232 HDCP Version V1.1 HDMI Output Port 1 x HDMI female port Color Space YCbCr 4:2:2 16/20/24 bits Deep Colour RGB / YCbCr 4:4:4 24/30/36 bits Human body model: ± 10kV (air-gap discharge) ESD Protection ±...
Need help?
Do you have a question about the EL-C61C and is the answer not in the manual?
Questions and answers