Installation And Wiring Method (Optional); Installation Method When Adding Eev Module; Wiring Method When Adding Eev Module - LG PAHCNM000 Owners & Installation Manual

INSTALLATION AND WIRING METHOD
(OPTIONAL)

Installation method when adding EEV module

Ex : Installation method when additional EEV module required.
1. Pull the supporter of the EEV module to
both sides.

Wiring method when adding EEV module.

12 V
GND
<Ex : When add 3EA more EEV module>
CAUTION
!
• When adding more than one EEV module, check if the power and communication cables
are connected correctly.
Otherwise, the product will not work properly.
• After adding EEV module, set the SW2 address. Otherwise, the product will not work
properly.
• Inverter Drive kit's BUS A and B must be wired in the last EEV add-on module.

INSTALLATION AND WIRING METHOD (OPTIONAL)

2. Using holes inside of AHU CONTROL KIT,
M4 screws(2EA) and extended supporter's
holes for Installation.
12 V 12 V
GND GND
<UI module>
Main module
<UO module> <EEV module>
<Wiring diagram>
17