Iot Connector Interfaces - mangOH Yellow Hardware Architecture Manual

mangOH Yellow Hardware Architecture Guide

2.6 IoT Connector Interfaces

The mangOH Yellow provides one IoT Connector (CN601), which supports the signals defined in the Project
mangOH IoT Expansion Card Design Specification, as detailed in
The default configuration (enabled signals) for the IoT Connector is shown in
The IoT Connector interface configuration can be modified as detailed in
Table 2-9: IoT Connector Interface Configuration Changes
Change type
Software Enable/disable identified signal(s) on
a specific IoT Connector.
CF3
HSIC
SDIO
UART1
SPI1
ADC0
I2C1
GPIO42
SPI1_SRDY
GPIO7
GPIO8
GPIO36
N_RESET
RESET_N
PCM
DR_SYNC
GPIO40
ADC3
Figure 2-25: IoT Connector Configuration
Rev 2 Oct.19
Change effect
USB
SDIO
UART
SPI
ADC0
I2C
CARD_DETECT_IOT0
GPIO_1
GPIO_2
GPIO_3
GPIO_4
N_RESET
PCM
PPS
Table 2-2 on page
Method
API command
IoT Connector #0
(CN601)
34
16.
Figure 2-25.
Table 2-9.
Change duration
Modifies running configuration until device
reboots or another change is made.
Note: Default configuration — Solid lines
Alternate configuration — Dashed lines
41113116