Advertisement
Table of Contents
Cleaning
WARNING
Never use steam cleaners.
-
-
Before cleaning, ensure that the cooking zones are switched off and that the residual heat
indicator ("H") is not displayed.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
•
After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
•
Sugar or foods with a high sugar content damage the hob and must be immediately removed.
•
Salt, sugar and sand could scratch the glass surface.
•
Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer's
instructions).
Troubleshooting guide
•
Read and follow the instructions given in the section "Instructions for use".
•
Check that the electricity supply has not been shut off.
•
Dry the hob thoroughly after cleaning it.
•
If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table
for instructions.
•
If the hob cannot be switched off after using it, disconnect it from the power supply.
ERROR CODE
C81, C82
F42 or F43
F12, F21, F25, F36, F37,
F40, F47, F56, F58, F60
Noises made by the hob
Induction hobs can make whistling or crackling sounds during normal operation, these actually come
from the pots and pans as a result of the characteristics of the bottoms (for example, bottoms made of
several layers of material, or uneven bottoms). These noises vary depending on the pots and pans used
and the amount of food they contain, and are not indicative of a defect of any kind.
In addition, the induction hob is equipped with an internal cooling system to control the temperature of
electronic parts; as a result, during operation and for several minutes after the hob has been switched off,
the noise of the cooling fan will be audible. This is perfectly normal and indeed essential for proper
functioning of the appliance.
DESCRIPTION
The control panel
switches off because of
excessively high
temperatures
The connection
voltage is wrong
Call the After-Sales Service and specify the error code.
POSSIBLE CAUSES
The internal
temperature of
electronic parts is too
high
The sensor detects a
discrepancy between
the appliance voltage
and that of the mains
supply
16
ERROR ELIMINATION
Wait for the hob to cool
down before using it
again
Disconnect the hob
from the mains and
check the electrical
connection
Advertisement
Table of Contents
