Getting Started; Installing Your Ktc-500Dab - Kenwood KTC-500DAB Manual

Getting started

Installing your KTC-500DAB

Before you can start using your KTC-500DAB, you need to do the following:
1. Connect the microphone to the antenna.
2. Position the antenna in your vehicle.
3. Position the microphone in your vehicle.
4. Connect the antenna to your vehicle's audio system, either with an auxiliary cable or by FM radio.
5. Install the wireless controller.
6. Switch your KTC-500DAB on for the first time.
Vehicle requirements
Fitted audio system with auxiliary (3.5mm) port or FM receiver.
l
Standard 12V negative earth power supply. Your KTC-500DAB is not suitable for use with a 24V power supply.
l
Getting the best DAB signal
As with FM radio, DAB signal coverage changes depending on your location. As you use the KTC-500DAB in your vehicle, you may
travel through areas where DAB signal coverage is poor.
To help get the best DAB signal when coverage is poor or there is a weak signal:
Follow the installation instructions carefully.
l
Ensure the magnetic grounding tail is attached to the antenna.
l
Use the supplied 12V power adapter, as other third-party adapters can cause interference.
l
Switch off other devices in your vehicle that aren't in use. Devices such as satellite navigation systems and dashboard cameras
l
can cause interference.
6