Hcec Setup - LG LU34 Z Series Installation Manual

HCEC Setup

1 Go to General -> HCEC Setup.
(1) HCEC Setup
(a) CEC Mode
* TVLink-CEC is only for LU5**H Series
• You will have 3 modes to choose Default, HCEC and TVLink-CEC.
• If Default is selected, you can use SIMPLINK which is provided in LG TV. Also you can
enable and disable SIMPLINK through SIMPLINK MENU.
• If HCEC is selected, you can use TVLink-HCEC Protocol. (For more detailed information,
please refer to TVLink-HCEC Protocol document)
• If TVLink-CEC is selected, TV will not directly work for key input except for power key. And
volume related keys will work just in case of Follower volume control mode. (For more
detailed information regarding the scenario of volume control, please refer to "TVLink-CEC
protocol" document)
(b) IR Decoding
• When IR Decoding is set to Enable, the TV decodes and changes it into a CEC Message and
sends it to Command via the HDMI CEC Line. The default value is Disable.
(c) Device ID
• Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose
between All and E.
• The default value is All.
(d) Stand By
• Sets the sending and receiving scenario of the operation about [CEC Op standBy(0x0c)
Command(Device Power)].
• The detailed scenario is described on the table below.
Send Only
Receive Only
Off
Send
All
Receive
O
O
X
X
O
X
O
X
29