CEM Systems Door Interface Unit DIU 210 Specification

DIU 210
Door Interface Unit
OVERVIEW
The Door Interface Unit (DIU 210) is designed primarily to provide power to a door
lock, as well as local power to a CEM reader when a high level of security is required.
It has onboard inputs which can be used to monitor conditions such as a fire alarm or
activated Break-glass condition.
The DIU 210 improves door security, by allowing the installer to locate lock controls
on the secure side of a door, with an intelligent CEM reader on the unsecured side. The
DIU 210 communicates with an intelligent CEM reader over a single pair RS485 cable.
Upon a valid swipe at the card reader, the reader will instruct the DIU (over the RS485
communications channel) to activate the appropriate output to release the lock using a
coded data signal (i.e. coded lock).
As an added benefit, the DIU 210 monitors the status of all standard door monitoring
inputs; inputs on an intelligent CEM reader are free for use as general purpose inputs
The DIU 210 is supplied in a steel enclosure complete with power supply backplane and
an output for an additional door holder.
DIU 210
www.cemsys.com
1. DIU Unit Enclosure
2. CEM Reader
3. Sounder
4. Break Glass Unit
5. REX/ Exit Reader or
Secure side push button
6. Door Holder
7. Door Lock
8. Lock Sense
9. Door Position sensor
FEATURES
• Door Interface Electronics
held on one board
• Provides 'coded lock' serial
interface between door
hardware and card reader
• On site selectable for 12V or
24V lock output
• Fire alarm and break glass
inputs for emergency door
release
• Designed for ease of
installation and maintenance
using 2 part connectors
throughout
• Compliant with EN55022
(emissions) and EN55024
(access control immunity)
• Backup battery connection for
emergency power