Black & Decker BDOJ620 Original Instructions Manual page 24

ENGLISH
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time.
Labels on tool
The following symbols are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Electrical safety
This tool is double insulated; therefore no
earth wire is required. Always check that
the power supply voltage corresponds to
the voltage on the rating plate.
♦ If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to
avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Saw blade locking lever
4. Shoe plate
5. Dust extraction outlet
6. Pendulum stroke/AutoSelect dial
Assembly
Warning! Before attempting any of the following
operations, make sure that the tool is switched
off and unplugged and that the saw blade has
stopped. Used saw blades may be hot.
24
(Original instructions)
Fitting the saw blade (fi g. A)
♦
♦
♦
♦
Connecting a vacuum cleaner to the tool (fi g. B)
♦
Residual risks
Additional residual risks may arise when using the
tool which may not be included in the enclosed
safety warnings. These risks can arise from
misuse, prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be avoided.
These include:
♦
♦
♦
♦
♦
Use
Adjusting the shoe plate for bevel cuts (fi g. C)
Warning! Never use the tool when the shoe plate
is loose or removed.
The shoe plate (4) can be set to a left or right bevel
angle of 22.5° or 45°.
♦
♦
♦
To reset the shoe plate (4) for 90° cuts:
♦
♦
♦
Hold the saw blade (7) as shown, with the teeth
facing forward.
Push the locking lever (3) away from the shoe
plate (4).
Insert the shank of the saw blade into the blade
holder (8) as far as it will go.
Release the locking lever (3).
Slide the vacuum nozzle into the dust extration
outlet (5).
Injuries caused by touching any rotating/
moving parts.
Injuries caused when changing any parts,
blades or accessories.
Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
ensure you take regular breaks.
Impairment of hearing.
Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech and
MDF.)
Loosen the screw (10).
Pull the shoe (4) forward, rotate the shoe to the
left or right and push it back into the 22.5° or
45° location.
Tighten the screw.
Loosen the screw (10).
Pull the shoe (4) forward, rotate to the centre
and push it back into the 0° location.
Tighten the screw.