Honeywell NOTIFIER ID2000 Series Installation & Commissioning Manual page 62

ID2000 Series Installation & Commissioning Manual
Power Supply Unit (PSU)
Kit PSU7A (PN:020-579).
For specification details, refer to 997-277-000-X (PSU7A installation)
and 997-267-000-X (DTP/Booster Installation)
Kit PSU3A (PN: 020-648)
Maximum current consumption: 1.6A
Output ratings:
Output voltage:
(PSU3A Unboosted output not used in ID2000)
Ripple voltage:
Max. output current quiescent:
Max. output current alarm:
EN54 Battery Wiring Test Impedance: 0.15 Ohm
EN54-4 PSU Loadings:
I : 600mA @ 26Vdc; I
max(a)
Battery Charger Ratings:
Battery charger output:
Temperature compensation:
Battery fuse rating:
Final end battery voltage:
Charger ripple voltage:
Panel PSU Input Range:
Batteries:
Internal batteries:
Maximum battery ratings:
Outputs:
i) Two dedicated Sounder Outputs
ii) Two Sounder or Volt-free Contact (VFC) - selectable outputs
iii) Two VFC outputs dedicated to Common Fire and Common Fault.
iv) Two standard, or optionally up to 8 loop outputs.
v) Two 24Vdc auxiliary outputs
For fuse information refer to Appendix 1, 1.2.
A2 - 3
26.0Vdc-28.3V dc
±300mV
600mA
3A
: 3.0A @ 26Vdc; I
max(b)
27.3V (nom) @ 20° C
-3mV/°C/cell
T 6.3A 250V H
Appendix 1, Section 1.2)
21V
140mV rms
25.5Vdc - 28.5Vdc
(measured at Baseboard Input)
Two 12V, 12-38Ah sealed, lead-acid types
MUST be used. Their lifetime depends
on the ambient temperature; refer to the
battery manufacturer's technical
specification for guidance. (Refer to PSU
specification for charger limitations).
Back Box & Battery Type Option:
Standard back box:
Extended/double extended back box:
Extended deep/double-extended deep
back box:
Externally mounted battery cabinet
997-433-000-5, Issue 5
: 0mA
min
(see
Yuasa
12Ah
17Ah
38Ah
130Ah
May 2010