care and cleaning
Always switch off, unplug and
dismantle before cleaning.
Your blender is fitted with an
overload protection device which will
stop the blender operating if the unit
If this happens, switch off, unplug
and remove excess ingredients from
Allow the blender to rest for a few
minutes. Then press the reset button
located on the underside of the
Wipe with a damp cloth, then dry.
Do not immerse the power unit in
Store excess cord around the
at the back of the power
goblet with fixed blades
1 Fill with warm water, fit the lid and
filler cap, then switch on for 20-30
2 Empty, then rinse, if further cleaning
is required, use a brush.
3 Wipe, then leave to air-dry.
Do not dishwash the goblet.
lid/filler cap/stir stick
Wash by hand, then dry.
Do not place any parts in the
service and customer
If you experience any
problems with the operation
of the blender, before calling
for assistance refer to the
troubleshooting guide or visit
If you need help with:
using your appliance or
servicing, spare parts or repairs (in
or out of guarantee)
Z call Kenwood customer care on
023 9239 2333. Have your
model number (e.g. TYPE
BLP90) and date code (5 digit
code e.g. 13L35) ready. They
are on the underside of the power
spares and attachments
Z call 0844 557 3653.
If you experience any problems with
the operation of your appliance,
before requesting assistance refer
to the "troubleshooting guide"
section in the manual or visit
Please note that your product
is covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
If your Kenwood product
malfunctions or you find any
defects, please send it or bring
it to an authorised KENWOOD
Service Centre. To find up to date
details of your nearest authorised
KENWOOD Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
Designed and engineered by
Kenwood in the UK.
Made in China.