Husqvarna HA110 Operator's Manual page 7
Hide thumbs
Also See for HA110:
- Operator's manual (13 pages) ,
- Operator's manual (11 pages) ,
- Operator's manual (40 pages)
Table of Contents
Advertisement
Available languages
Available languages
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
In this section the product’s safety features, its purpose
and how checks and maintenance should be carried out
to ensure that it operates correctly. See instructions
Introduction on page 2 to find where
under the heading
these parts are located on your product.
The life span of the product can be reduced and the risk
of accidents can increase if product maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
WARNING: Never use a product with
defective safety components. The product's
safety equipment must be inspected and
maintained as described in this section. If
your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION: All servicing and repair work on
the machine requires special training. This is
especially true of the machine′s safety
equipment. If your machine fails any of the
checks described below you must contact
your service agent. When you buy any of
our products we guarantee the availability of
professional repairs and service. If the
retailer who sells your machine is not a
servicing dealer, ask him for the address of
your nearest service agent.
To do a check of the hand guard (HA110, for gasoline
products only)
The hand guard prevents hands from coming in contact
with the moving blades, for example, if the operator
loses grip on the front handle.
1. Check that the hand guard is fitted correctly.
2. Check that the hand guard is undamaged.
To do a check of the blades
To ensure good cutting results it is important that the
contact pressure between the blades is correct.
1. The contact pressure is adjusted by turning the
screws on the underside of the bar clockwise as far
as they will go.
2. Then turn the screws anticlockwise a 1/4 turn.
3. Lock the screws using the locking nut on the top of
the bar.
4. Check that the screws are loose enough to allow the
washers under the screw heads to slide sideways.
5. When the blades are correctly adjusted the play
between the blades should be 0,2–0,4 mm,
measured at the screws.
6. The edges of the blades are too hard to be filed. Dull
blades should be sharpened using a grinder.
7. Replace the blades if they are bent or damaged.
Hot surface
The gear housing gets hot when the product has been in
use. Do not touch the gear housing to avoid burning
yourself.
Safety instructions for maintenance
Read the warning instructions that follow before you use
the product.
•
Always stop the product before you work on any part
of the cutting equipment. If you have a gasoline
operated product, disconnect the spark plug cap
from the spark plug. If you have a battery operated
product, remove the battery. Check that the cutting
equipment has stopped completely before you start
any work on it.
•
The transport guard should always be fitted to the
cutting attachment when the product is not in use.
•
Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
Page 7
Advertisement
Chapters
Table of Contents
