Running A Test Procedure; Running The Test Procedure On A Preconfigured Environment; Configure Name Filter Parameter - IBM DS8000 User Manual

Figure 39. Configure Name Filter parameter
Related tasks:
"Adding Array Manager to VMware Site Recovery Manager" on page 41
To add arrays to the VMware Site Recovery Manager, complete the following steps.

Running a Test procedure

Depending on the SRA configuration, it might be necessary to perform extra tasks
for the Test procedure to work.
Attention: If you encounter a failure during the Test procedure, check to see if
the remote copy status is the same as the original state. If NOT, manually restore
the remote copy status back to its original state after cleanup procedures.
For troubleshooting information, see "Test failures" on page 56.

Running the Test procedure on a preconfigured environment

The IBM DS8000 SRA completely automates the Test procedure.
50
IBM DS8000 Storage Replication Adapter