Husqvarna PG 540 Operator's Manual page 21

WARNING: Do not move the product on
steep slopes. Look at the rating plate on the
product for information about the maximum
slope angle.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
• Do not turn the product more than 45° on a ramp.
To lift the product
WARNING: Make sure that the lifting
equipment has the correct specification to lift
the product safely. The rating plate on the
product shows the product weight.
WARNING: Do not walk or stay below or
near a lifted product. Keep bystanders away
from the risk area. Refer to
on page 7 .
WARNING: Do not lift a damaged product.
Make sure that the lifting eye is correctly
installed and not damaged.
1. Set the product in transport position. Refer to
the product in transport position on page 20 .
2. Attach the lifting equipment at the lifting eye.
To attach the product to a
transportation vehicle
The product has holes that are used with tie-down
straps to attach the product to the transportation vehicle.
1211 - 003 - 22.01.2020
1. Attach the tie-down straps in the holes.
Work area safety
2. Attach and tighten the tie-down straps to the vehicle.
Storage
To set
•
•
•
•
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
CAUTION: Do not put the product in storage
outdoors. Always keep the product indoors.
Keep the product in a dry and frost free area.
Clean the product and do a complete servicing
before you put the product in storage.
Keep the grinding head on the ground.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
4X
21