Table of Contents
Advertisement
About Test Labels
Print a Test Label in Start Up Mode
PD43 and PD43c Commercial Printer User Manual
Before you calibrate the sensor, load media and ribbon in the printer
as necessary.
1 In the Main Menu, select Wizards > Calibration > Label Taken
Sensor.
2 Follow the prompts to calibrate the sensor.
You can print a test label to check print quality and get configuration
information, including lists of the fonts, images, and applications
installed on the printer. Use one of these methods to print a test label:
•
In Start Up mode
•
In Idle mode
•
From the Main Menu
•
From PrintSet 5
You can also print test labels from the printer web page, which requires
a network connection to a desktop PC. You need to know the printer
IP address to view the printer web page.
You can print a test label when you first turn on the printer.
1 Make sure that the printer has media and ribbon (if necessary)
installed.
2 Connect the printer to power and turn on the printer.
3 On the icon printer, when the last two LEDs are lit (Maintenance
and Bluetooth), press and hold
print.
On the LCD printer, when the status bar appears, press and hold
until the Media Calibration Wizard appears. Select
press
to print a label with the current print settings.
Chapter 2 — Set Up the Printer
until the test label starts to
and
69
Advertisement
Table of Contents
