Subscribe to Our Youtube Channel
Related Manuals for Evolution Aqua ceTus
Summary of Contents for Evolution Aqua ceTus
- Page 1 Installation and Instruction Manual Evolution House 4-6 Kellet Close Wigan, WN5 0LP United Kingdom Ph: +44 (0) 1942 216 554 Fax: +44 (0) 1942 216 562 Web: www.evolutionaqua.com Email: info@evolutionaqua.com...
- Page 2 INTRODUCTION Thank you for purchasing your Cetus Sieve. We are sure you will be delighted with its performance. Your Cetus will have been shipped to you either as a gravity or a pump fed unit. What’s in the Box: Fig 1.1...
- Page 3 OPERATION Basic Operation of the Cetus: The Cetus is a self adjusting sieve which can be installed either gravity fed or pump fed, enabling the pre ltering of your pondwater before the water enters your current lter system. It also can be used as a standalone unit to remove leaves and other oating debris from your pond via a skimmer.
- Page 4 CETUS INSTALLATION The Cetus needs to be installed on a solid level base so that it doesnt de ect under its own weight. It is recommended to use a 100mm thick concrete plinth, although decking or paving slabs can be used.
- Page 6 PUMP FED - INSTALLATION The Cetus when installed as a pump fed unit ,needs to have the extra components (Figures 1.4 and 1.5) connected as in Figure 5. This will enable a 1.5” (50mm) hard pipe or hosetail for exible pipe to be tted, connecting your pump to the Cetus.
- Page 7 Fig 9 The 4” (110mm) pipe between the Cetus and the lter will allow water to pass in the direction of the higher demanding unit (it is recommended that the pump from the Cetus has a higher owrate than the pump from the lter.
- Page 8 DUAL GRAVITY FED - INSTALLATION To explain this system in better detail, diagram 10 below is a top view schematic of how to install a dual gravity fed Cetus and lter. The following points relate to the ows within the system Fig 10 1) Water leaves the pond via a 4”...
Need help?
Do you have a question about the ceTus and is the answer not in the manual?
Questions and answers