Insertion And Removal Of The Sd Memory Card - Mitsubishi Electric MELSEC iQ-F Series User Manual

Insertion and removal of the SD memory card

The following explains insertion and removal of the SD memory card.
Insertion procedure
Mount the SD memory card. Pay attention to the direction of the card and follow the procedure below.
(1)
Removal procedure
(3)
(1)
Precautions
• When mounting or removing the SD memory card while the power is ON, follow the above-mentioned procedure.
Otherwise, the data in the card may be broken.
• When removing the SD memory card which is being accessed by any function, the CARD LED is turned OFF after the
access is completed. When the CARD LED is turned OFF depends on the accessing function.
• When SM605 (mount and remove memory card disabling flag) is ON, the CARD LED is not turned OFF even if the SD
memory card stop switch is pressed. If the CARD LED is not turned OFF, turn ON SM606 (instruction of forcibly stop using
SD memory card) so that the SD memory card cannot be used.
1.
2.
3.
4.
(2)
1.
2.
(2)
Insert the SD memory card (1) straight into the SD
memory card slot. Make sure that the notch of the card
is directed downward. After mounting, check that the
card is mounted completely. If the card is mounted
incompletely, malfunctions may occur because of poor
contact.
The CARD LED (2) blinks until the SD memory card
becomes available.
The CARD LED turns on when the SD memory card is
available.
If the CARD LED dose not turn on even though the SD
memory card is mounted, make sure that SM606
(forcibly stop using SD memory card instruction) and
SM607 (forcibly stop using SD memory card flag) are
OFF by using engineering tools.
Press the SD memory card stop switch (1) for one
second or more to stop access to the card. The CARD
READY LED (2) blinks during the access stop
operation, and then the LED is turned OFF when the
operation is completed.
Insert the SD memory card (3) once, and then pull it
straight.
Appendix 5 SD Memory Card
A
APPX
167