After Use - Makita DHW080 Instruction Manual

3. Open the cover and install the battery cartridges
into the high pressure washer and then lock the cover.
2
► 1. Battery cartridge 2. Cover
4.
Turn the power switch to your desired mode.
2
1
OFF
LOW HIGH
► 1. Low pressure mode 2. OFF position 3. High
pressure mode
5. To eject a water jet, unlock the stopper and
squeeze the trigger. The jet continues as long as the
trigger is squeezed.
1
► 1. Stopper
CAUTION:
Hold the trigger gun firmly. The
trigger gun recoils when you pull the trigger.
CAUTION:
Always hold the trigger gun by the
grip and barrel when ejecting water jet.
1
3
NOTICE:
Be careful not to pull the trigger gun
forcibly during operation. It may cause the high
pressure washer to fall over.
NOTICE:
When suspending the operation for a
long time, switch off the high pressure washer
and squeeze the trigger to discharge the remain-
ing water fully.
If the high pressure washer is left for a long time while
maintaining high pressure, it may not restart. In this
situation, switch off the high pressure washer, sup-
ply water from a faucet to the inlet and squeeze the
trigger with keeping the water supply for a while. And
then, switch on the high pressure washer.
When you suspend the operation, you can temporarily
place the trigger gun as shown in the figure.

After use

CAUTION:
After operating the high pressure
washer, always perform the procedure described
in this manual. Residual pressure in the trigger gun
or high pressure washer can cause personal injury or
damage to the pump inside.
1. Switch off the high pressure washer.
2. Close the faucet and disconnect the water hose
from the high pressure washer.
3. Switch on the high pressure washer again.
16 ENGLISH