Mks-9011/9012 Rear Panel - Sony CCP-9000-C Operation Manual

MKS-9011/9012 Rear Panel

EXT DISPLAY DATA
qaDATA connector
qsEXT DISPLAY connector
a MENU PANEL connector (D-sub 50-pin,
special interface)
Connect to the menu panel.
b EXT (extension) PANEL connector (D-sub 50-pin,
special interface)
Connect to the MKS-8075 Extension Adaptors to install
operation modules apart.
c - AC IN (AC power input) A and B connectors
(3-pin)
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
d GPI (General Purpose Interface) connector
(D-sub 25-pin)
Connect to external devices for input and output of trigger
signals. Up to eight inputs and eight outputs are possible,
with input and output conditions set on the center control
panel.
1MENU PANEL connector
2EXT PANEL connector
MENU PANEL EXT PANEL EDITOR PANEL
3 - AC IN A and B connectors
B
REF IN REMOTE CTRL PERIPH
5U terminal
6PERIPH connector
7CTRL connector
8REMOTE connector
9REF IN connectors
0EDITOR PANEL connector
e U (signal ground) terminal
Connect to the system ground.
f PERIPH (peripheral) connector (RJ-45)
Connect to the DCU-8000 Device Control Unit Pack with
a cross cable to enable communications with the DCU-
8000.
Note
An Ethernet switch is required to connect two or more
DCU-8000 Device Control Units.
Caution
When using a LAN cable: For safety, do not connect to a
connector for peripheral device wiring that might have
excessive voltage.
A
GPI
4GPI connector
Location and Function of Parts
9