Equipment Connection Warnings • Do not use Tripp Lite UPS Systems for life support applications in which a malfunction or failure of a Tripp Lite UPS System could cause failure or significantly alter the performance of a life-support device.
UPS jack marked “EQUIP” (or “OUT”). OPTION 2 (UPS Software) Using Tripp Lite cable (if supplied), connect the DB9 port of your computer to the DB9 port of your UPS. Load software (if supplied) and run installation program appropriate for your operating system.
UPS charge its batteries for 12 hours and repeat the test. If alarm still sounds, contact Tripp Lite for service. CAUTION: Do not unplug your UPS to test its batteries. This will remove safe electrical grounding and may introduce a damaging surge into your network connections.
Page 5
This yellow light will turn ON after you test your UPS battery’s charge with the “Mute/Test” Switch to indicate that the UPS’s battery is less than fully charged. If it stays on continuously, contact Tripp Lite for service. The light will flash after you set the Available on select “OFF/ON”...
Service If returning your UPS to Tripp Lite, contact your local Tripp Lite dealer or distributor. You will be referred to a service center. Carefully pack the UPS using the ORIGINAL PACKING MATERIAL that came with the unit.