Appendix Ii. Device Maintenance - Owon VDS6000 Series Quick Manual

Appendix II. Device Maintenance

Storage
To avoid any possible damage to the device, and probe, keep these items FAR AWAY
from sprays, liquids, or solvents.
Surface Cleaning
As per the operation condition requirements, DO check the device and probe surface from
time to time.
When cleaning the device / probe surface, please follow up with operation steps as
follows -
i. Before the surface cleaning, making sure the device is powered off, without any
accessory / outer facility connected; making sure probe not working with device /
outer facility.
ii. Use non-electrostatic soft cloth to remove the surface dust.
iii. For further surface cleaning, a wet-but-no-water-dripping soft cloth could be used,
with soft detergent also works.
Note: To avoid permanent damage to the surface of device and probe, DO NOT introduce any corrosive
chemical cleaner / detergent.
Warning:
After device surface cleaning, before working the device for next time, please
confirm that the device surface in a relative dry condition, so as to avoid any
short circuit risk, or possible body injury caused by electric conduction from the wet
surface.
Lilliput (OWON)
04/2020 ISSUE.
- 19 -