Download  Print this page

Tripp Lite SmartPro 1400 XL Mounting Instructions

Wallmount bracket for the smartpro 1400xl net, bp-36v27 and snmp solo
Hide thumbs
   

Advertisement

1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
A
Mounting the Bracket
on a Wall
Hold the Bracket level
against the intended mount-
ing surface and mark the
locations of the mounting
holes (A). Drill 1/8" guide
holes in these locations.
Place the included wash-
ers around the included
screws, then drive the
screws through the mount-
ing holes and into the guide
holes.
CAUTION: The hardware
(screws and washers) in-
cluded with the Bracket is
only intended for use with
plywood surfaces. To mount
your Bracket on a different
surface, you must determine
a safe mounting procedure
and obtain proper hardware.
Copyright © 2000 Tripp Lite. All rights reserved. SmartPro
B C
D
Mounting a SmartPro
or Battery Pack
CAUTION: Before mounting
a SmartPro UPS, make sure
the UPS is OFF and un-
plugged. Before mounting a
BP-36V27 battery pack,
make sure that the battery
pack is disconnected from
your SmartPro system. The
UPS or battery pack is ex-
tremely heavy. Take care to
avoid injury while lifting.
Place the UPS or battery
pack in the mounting tray.
The feet of a UPS should
press against the rear ridge
(B) and fit around the center
ridge (C) while the front of
the UPS presses against the
front ridge (D). The base of
a battery pack should fit
between the rear (B) and
center (C) ridges, with its
cords facing the wall.

Mounting Instructions

Wallmount
Bracket
for the SmartPro
BP-36V27 and SNMP Solo
ESPAÑOL: p. 2
®
is a registered trademark of Tripp Lite.
®
1400XL NET,
FRANÇAIS: p. 2
E
Next, Pass the safety strap
around the UPS or battery
pack
and
through
mounting tray as shown.
The safety strap should pass
through the tray's outer strap
holes for a UPS or through
the tray's inner strap holes
for a battery pack. Fully
tighten the safety strap and
fasten the velcro end.
Mounting a SNMP Solo
Affix one of the self-adhe-
sive velcro pads included
in the bottom of the bracket's
SNMP slot (E). Affix the
other pad to the long side of
the SMMP-Solo opposite its
indicator lights. Press the
velcro-covered side of the
SNMP-Solo into the bracket's
SNMP slot.
the

Advertisement

Table of Contents
loading

  Related Manuals for Tripp Lite SmartPro 1400 XL

  Summary of Contents for Tripp Lite SmartPro 1400 XL

  • Page 1: Mounting Instructions

    To mount your Bracket on a different surface, you must determine a safe mounting procedure and obtain proper hardware. Copyright © 2000 Tripp Lite. All rights reserved. SmartPro Mounting Instructions Wallmount for the SmartPro BP-36V27 and SNMP Solo ESPAÑOL: p.
  • Page 2 Instrucciones para el Montar el Soporte en la Pared Sostenga el nivel del Soporte contra la superficie sobre la cual desea montar la unidad y marque las ubicaciones de los hoyos de montaje (A). Taladre hoyos de guía de 1/8 pulgadas de acuerdo a las marcas realizadas.