4 HOLE WITH DECKPLATE INSTALLATION
8 DECKPLATE INSTALLATION
Ensure that Plastic Putty Plate (8A) is pressed onto Deckplate (8B). Place a
bead of plumber's putty in the groove along the outer edge of Putty Plate (8A).
If desired, place a small bead of plumber's putty to the underside of Hose Guide
Flange (8D). Insert Hose Guide (8C) into Hose Guide Flange (8D) and onto
the sink hole. Install Deckplate (8B) over the holes in the sink.
9 SECURING DECKPLATE & HOSE GUIDE
From underneath sink, secure Hose Guide (9A) by screwing Plastic Locknut
(9B). Secure Deckplate (9C) by screwing Wing Nuts (9D) to Mounting Posts
(9E). Hand tighten. Caution: do not over-tighten. Remove any excess putty
from around the outside edge of Deckplate (9C).
10 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (10A) through Hose Guide (10B). From underneath
sink, feed Side Spray Hose (10A) back up through the center hole of sink and
through Deckplate (10C) so that it is above the sink.
Go To Step 15
3 HOLE WITH SINGLE POST & SOAP
11 MOUNTING RING & GUIDE FLANGE & SOAP
DISPENSER SHANK INSTALLATION
Insert Hose Guide (11A) through Hose Guide Flange (11B), insert Soap Dispenser
Shank (11C) through Foam Gasket (11D) and place Mounting Ring (11E) over
Plastic Gasket (11F) and into the sink holes. If desired, place a small bead
of plumber's putty to the underside of Hose Guide Flange (11B). Ensure that
Mounting Ring (11E) sits with Flats (11G) parallel with the outer sink holes.
12 SECURING HOSE GUIDE & SOAP DISPENSER SHANK
From underneath sink, secure Hose Guide (12A) and Soap Dispenser Shank
(12B) by screwing Plastic Locknuts (12C) and (12D). Hand tighten.
Caution: do not over-tighten.
13 SOAP DISPENSER INSTALLATION
From underneath sink, thread on Bottle (13A) to Shank (13B). Pour in liquid
soap (not included) into Shank Orifice (13C). Insert Pump Mechanism (13D)
into soap dispenser body. Install Dispenser Head (13E) by pushing firmly onto