Table of Contents
Advertisement
Using the Image Stabilizer
•
To use image stabilization, set the Image Stabilizer to ON.
The Image Stabilizer settings are explained
below.
D
EF (EF-S) lenses and RF lenses:
Use the Image Stabilizer switch on the lens (ON/OFF).
□
EF-M
lenses:
Select the setting on the camera ([ON/OFF]).
Attaching a Lens Hood
Align the hood with the edge of the lens and turn the hood
clockwise to attach it.
Using the Control Ring
This only applies to RF lenses equipped with a control ring.
Refer to the camera's instructions for information on using the
control
ring.
Nomenclature
G)
Lens mount index
~
Focus mode switch
@
Focusing ring
@
Zoom ring
®
Image stabilizer switch
®
Image stabilizer mode selector switch
MODE 1: Corrects vibrations in all directions.
MODE 2: When you take a panning shot either horizontally or
vertically,
corrects vibrations at right angles to the
direction of
panning.
MODE 3: Corrects vibration only during
exposure.
(J)
Focusing distance range selector switch
Selects the focusing distance
range.
@
Tripod mount (fixed-mount type)
Used to attach a tripod or monopod.
®
Tripod mount (detachable tripod type)
Used to attach a tripod or
monopod.
@) Lens-retraction
switch
Push the switch in the "•" direction while turning the ring to set
the lens to the ready position
.
@
Lock release switch
Push the switch in the ".A." direction while turning the ring to set
the lens to the ready
position.
@
Macro Lite ON button
Used to change the Macro Lites illuminated patterns.
@
Macro Lites
Illuminate the subject
@
Lens cap
@
Dust cap
@
Hood (bayonet type)
@
Hood (screw type)
@
Control ring
@
@
CD
@
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful
interference,
and (2) this device must accept any interference
received,
including interference that may cause undesired
operation.
Do not make any changes or modifications to the equipment unless otherwise specified in the
instructions.
If
such changes or modifications should be
made,
you could be required to stop operation of the equipment.
This equipment has been tested and found to comply with the limits for a class B digital
device,
pursuant to
part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment
generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the
instructions,
may cause harmful interference to radio
communications.
However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment
does cause harmful interference to radio or television
reception,
which can be determined by turning the
equipment off and on
,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio!TV technician for
help.
Advertisement
Table of Contents
