Cisco 8832 Manual page 12

Install the Conference Phone in Daisy Chain Mode
with the units or a pair of wireless microphones with the units, but not a mixed combination of the microphones.
When a wired microphone is connected to one of the units, it unpairs any wireless microphones that are
connected to the same unit. Whenever there is an active call, the LEDs and the menu options on the phone
screen of both units are synchronized.
Install the Conference Phone in Daisy Chain Mode
The daisy chain kit contains a Smart Adapter, a short LAN cable, two long, thicker USB-C cables, and a
shorter, thinner USB-C cable. In daisy chain mode, the conference phones require external power from an
electrical outlet. You must use the Smart Adapter to connect the phones together. The long USB-C cables go
to the phone and the short one goes to the power adapter. Refer to the following figure when you connect the
power adapter and the LAN port to the Smart Adapter.
Figure 7: Smart Adapter Power Port and LAN Port
You can use only one microphone per unit.
Note
You must use either two wired microphones or two wireless microphones with the phone, but not a mixed
combination.
The USB-C cable for the power adapter is thinner than the USB-C cables that connect to the phone.
Procedure
Step 1
Plug the power adapter into the electrical outlet.
Step 2 Connect the short, thinner USB-C cable from the power adapter to the Smart Adapter.
Figure 8: Smart Adapter USB Port Connected to the Power Outlet
Step 3 Required: Connect the Ethernet cable to the Smart Adapter and the LAN port.
Your Phone
12
Your Phone