Husqvarna PP 70 Operator's Manual page 9

To connect a power tool to the product
1. Remove the cover (A).
B
A
2. Connect the power tool to the outlet for tool
connection (B). If it is necessary, use an adapter.
Speak to your Husqvarna servicing dealer for more
information.
To start the product
1. Make sure that the machine stop button is
disengaged. Refer to
stop button on page 7 .
2. Push the ON button (A) to start the product.
A
To stop the product
1. Stop the connected power tool. Refer to the
Operator's manual for the power tool.
1244 - 003 - 26.05.2020
To do a check of the machine
2. Push the OFF button (B) to stop the product.
B
Status indication lamps
When the product is connected, the lamps 1-5 comes on
for some seconds.
1 2 3
4
1. Phase lamp (green)
2. Phase lamp (green)
3. Phase lamp (green)
4. Service indicator (yellow)
5. Warning indicator (red)
For more information about the status indication lamps,
Explanation of the status indication lamps on
refer to
page 10 .
Warning indicator
CAUTION: Do not continue to operate the
product when the warning indicator is on.
Risk of damage to the product.
If the warning indicator (red lamp) comes on, stop the
Explanation of the status indication
product. Refer to
lamps on page 10 .
5
9