Table of Contents
Advertisement
Programming Remote Controls
To Program The Remote Controls
1.
Cycle the vehicle's ignition switch to the ON position five (5) times. The LED on
the antenna will turn on solid to indicate the system is ready for remote control
programming.
2.
Press the
one (1) time to confirm the remote has been programmed.
3.
Repeat step 2 above for each additional remote control.
Replacing Remote Control Batteries
5 Button Remote Control - Model 185SP
The CR2032 battery inside each remote control should last approximately 1 year
under normal use. When the batteries become weak you will notice the remote control
range (the distance from the vehicle the remote control will work) deteriorate and the
small LED on the remote control will dim. To replace the remote control batteries:
1.
Using a coin, disassemble the halves of the remote control.
2.
Remove the old battery, observing the +/- symbols on the batteries and replace
with a new battery.
3.
Reassemble the halves of the remote control.
4.
Test operation of the remote control.
2 Way LCD Remote Control - Model 18RELCD
The battery inside the 2-way LCD remote control is rechargeable and should last
approximately 30-60 days under normal use. When the battery becomes weak you
will notice the remote control range (the distance from the vehicle the remote control
will work) deteriorate and the battery icon on the LCD remote control will show 1 bar
or less.
To recharge the remote control.
1.
On the back of the remote; Pull tab with USB symbol up and way from the back
case.
2.
Rotate USB tab from right to left to slide out the remote charging port.
3.
Press USB tab into place. The lock will engage.
Repeat the process above in reverse to stow the charging port.
2019 Voxx Electronics Corporation. All rights reserved.
button on the remote control. The LED on the antenna with flash
7
Advertisement
Table of Contents
