Service And Adjustments - Craftsman 944.361063 Owner's Manual

WARNING: To avoid serious injury,
before performing any service and
adjustments:
1. Stop engine.
2. Make sure the rotating lines and all
moving parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place wire where it cannot
come into contact with the spark plug.
TRIMMER
TO AD JUST TRIMMING HEIGHT
See "TO AD JUST TRIMMING HEIGHT" in
the Op er a tion sec tion of this manual.
TO ADJUST HANDLE
The upper handle may be adjusted to dif-
ferent height positions.
1. Loosen handle knob only enough to
allow the upper handle to pivot to the
desired position.
2. Tighten handle knob securely.
NOTE: The handle knob and bolt may be
reversed for left handed operation.
Upper
handle
Handle knob

SERVICE AND ADJUSTMENTS

12
TO REMOVE/REPLACE TRIMMER HEAD
DRIVE BELT
1. Remove screw at front of chassis cover.
2. Lift cover up and away from trimmer.
3. Remove the two (2) screws on sides of
trimmer securing the debris shield.
4. Turn trimmer on its side with car bu re tor
and fuel cap up.
5. Remove the two (2) screws on under-
side of trimmer securing the debris
shield.
6. Slide the debris shield rearward and
remove.
7. Remove belt from engine pulley on
crankshaft.
Engine
pulley
Screw
Chassis
cover
Debris shield screws