Pepperl+Fuchs AS-I 3.0 Manual page 34

AS-i 3.0 Command Interface
Commands of the Command Interface
Monitor state
Code significance
0 protective mode, everything OK (output circuits that are not installed, not con-
figured or dependent output circuits are indicated as OK)
1 protective mode, output circuit 1 off.
2 protective mode, output circuit 2 off
3 protective mode, both output circuits off.
4 configuration mode: power on
5 configuration mode
6 reserved / not defined
7 configuration mode: fatal device error, RESET or device replacement neces-
sary
Color coding
Code color
0 green
1 green flashing
2 yellow
3 yellow flashing
4 red
5 red flashing
6 grey
Information!
See also the separate "Safety-at-Work" monitor documentation for a description of the
codes used for monitor state, OSSD state, device colors and assignments to OSSDs.
34
meanining
block is in the ON state (switched on)
block is in the ON state (switched on), but already in the
transition to the OFF state, e.g. shutdown delay
block is ready, but is still waiting for a further condition, e.g.
local acknowledgement or Start button
time condition exceeded, action must be repeated, e.g. syn-
chronization time exceeded
block is in the OFF state (switched off)
the error interlock is active, clear using one the following
actions:
> Acknowledge using the ESC/Service button
> Power OFF/ON
> AS-i OFF/ON
OSSD not used / no communication with the AS-i slave
Tab. 4-47.
Tab. 4-48.