Pepperl+Fuchs AS-I 3.0 Manual page 159

AS-i 3.0 Command Interface
Command Interface Examples
No result because toggle bit = 0.
Set the toggle bit:
byte 1
byte 2
byte 3
byte 4
byte 5
byte 6
...
byte 12
byte 1
byte 2
byte 3
byte 4
...
byte 12
The single slave configuration for the 16-bit module is written.
This command must be repeated for all 31 A-slaves and all 31 B-slaves. If you
don't connect a slave to an address, write F
3. Write new list of projected slaves.
Write the complete LPS of your AS-i circuit.
Every bit in the LPS corresponds to one slave after the following scheme:
byte0/Bit 0: slave 0/0A - can not be set!
byte1/Bit 1: slave 1/1A
...
byte3/Bit 7: slave 31/31A
byte4/Bit 0: slave 0B - can not be set!
byte4/Bit 1: slave 1B
...
byte7/Bit 7: slave 31B
The slave is projected if the bit is set.
request: SET_PCD
0C (SET_PCD)
hex
80 (T = 1, master 1, single master)
hex
04 (slave address to write to master)
hex
EF (ID + IO to configurate)
hex
37 (ID + IO to configurate)
hex
00
hex
...
00
hex
response
25
hex
80 (T = 1, result = 0)
hex
00 (or old values)
hex
00 (or old values)
hex
...
00 (or old values)
hex
for ID, IO, ID1, ID2.
hex
Tab. 5-317.
Tab. 5-318.
159