Method Of Cleaning And Maintenance - Panasonic F-P15EHA Operating Instructions Manual

Method of Cleaning and Maintenance

Notice
As a reminder, it is recommended to perform cleaning and maintenance.
Cleaning of machine body.
(every 1~2 months.)
Dirt on the machine body
may be wiped by using a
cloth dampened with
water or a neutral
detergent.
Hook the left and right sides of the front panel left with two hands, followed by pulling it out to remove
the panel and remove the fore-filter.
Use clean water, neutral detergent or dust cleaner for cleaning, followed by drying and reinstalling it in
the machine body.
Time for cleaning and replacement of filter
The air volume at the air outlet becomes smaller and the sound becomes louder. Please check if it is
time to clean or replace the filter. Generally, it should be cleaned once every 1 month approximately.
Due to different environment for place of use, the service life of the HEPA dust collection filter also
differs. Generally, it should be replaced once every 2 years approximately.
HEPA dust collection filter for replacement (optional) : F-ZEHC15Z Please purchase it from your
Method for cleaning and replacement of filter
Remove the front panel, fore-filter.
For the approach of removing the fore-filter,
please refer to Cleaning of Fore-filter
mentioned above.
Reach in the lower edge of the front panel
and pull forward to remove the front panel.
Take the filter out of the machine body.
Remove the fore-filter prior to removal of the
HEPA dust collection filter.
Make sure to disconnect the power plug before cleaning the product.
(Otherwise, the product might operate with the possibility of electric
shock or injury.
Cleaning of Fore-filter
Cleaning and replacement of filter
Fore-filter
Sweep of the air suction vent.
(every 1~2 months.)
For dust in the air suction
vent, please wipe it with a
dry cloth or clear it with a
dust cleaner.
(every 1~2 months.)
(every 1 month.)
nearest service station or dealer.
Replacement or cleaning of the filter is
determined according to the dirty conditions
on the surface of the filter.
In renewal
Please remove the filter from the plastic bag as
it is just purchased or replaced.
In cleaning
Simply clean the surface of the filter with a dust
cleaner.
Never use water washing and
brush for cleaning.
Install fore-filter, front panel, plug in the
power plug.
After replacing the filter, in the power-on state,
please long press the Timer/Filter reset (press
3 sec) key for 3 seconds until a long tone
sounds, and the replacement time for the filter
is recounted.
Remind As a reminder, use dust cleaning to suck
dust for the HEPA dust collection filter, and
never wash it with water in order not to lose
function of the filter.
9