Bosch Professional GOP 18V-28 Instructions Manual page 19

(8) is pressed unintentionally. The battery is held in place by
a spring when fitted in the power tool.
To remove the battery (3), press the battery release button
(8) and pull the battery to the rear and out of the power tool.
Do not use force to do this.
Battery charge indicator
The green LEDs on the battery charge indicator indicate the
state of charge of the battery. For safety reasons, it is only
possible to check the state of charge when the power tool is
not in operation.
Press the button for the battery charge indicator or
show the state of charge. This is also possible when the bat-
tery is removed.
If no LED lights up after pressing the button for the battery
charge indicator, then the battery is defective and must be
replaced.
Battery model GBA 18V...
LEDs
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
The following table shows examples of application tools. You can find additional application tools in Bosch's extensive range of
accessories.
Application tool
AIZ 10 AB
Starlock
10 × 20 mm bi-
metal plunge cut
saw blade for wood
and metal
AIZ 32 EPC
Starlock
32 × 50 mm HCS
plunge cut saw
blade for wood
AIZ 32 APB
Starlock
32 × 50 mm bi-
metal plunge cut
saw blade for wood
and metal
Bosch Power Tools
Battery model ProCORE18V...
LEDs
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
to
1× flashing green light
Changing the tool
Wear protective gloves when changing tools. There is
u
a risk of injury when touching the application tools.
Selecting an application tool
Please observe the application tools intended for your power
tool.
Application tool
Capacity
60−100 %
30−60 %
5−30 %
0−5 %
Material Application
Softwood, soft plastics, Smaller separation and plunge cuts; delicate adjustment
gypsum, thin-walled alu- work in wood;
minium and non-ferrous Example: Cutting recess for cable, plunge cuts in gypsum
metal profiles, thin metal boards, resawing recesses for locks and fittings
sheets, non-hardened
nails and bolts
Softwood Splinter-free separation and plunge saw cuts thanks to
round sawing edge (Curved-Tec);
also for sawing close to the edge, in corners and difficult-
to-access areas;
Example: Plunge cut for the installation of a ventilation
grille or recess for plug sockets
Composite materials Tear-free flush cuts and plunge cuts in wood, soft non-fer-
made from wood and soft rous metals and plastic thanks to round sawing edge
non-ferrous metals, un- (Curved-Tec);
hardened nails and Example: Recess for plug sockets and pipes, flush cuts
screws, pipes made from through unhardened nails and screws
non-ferrous metal and
profiles with small dimen-
sions
English | 19
Capacity
80−100 %
60−80 %
40−60 %
20−40 %
5−20 %
0−5 %
GOP 18V-28
1 609 92A 5NM | (04.06.2020)