Amd Chipset Setting - DFI GH551 User Manual

Advanced NCT5525D HW Monitor
X X
► Smart Fan Function
Aptio Setup Utility - Copyright (C) 2020 American Megatrends, Inc.
Advanced
CPU Smart Fan Control
CPU Smart Fan Mode <Enable>
Boundary 1 [30]
Boundary 2 [40]
Boundary 3 [50]
Boundary 4 [60]
Fan Speed Count 1 [35]
Fan Speed Count 2 [60]
Fan Speed Count 3 [80]
Fan Speed Count 4 [100]
Version 2.20.1274. Copyright (C) 2020 American Megatrends, Inc.
Smart Fan is a fan speed moderation strategy dependent on the current system temperature.
When the system temperature goes higher than the Boundary setting, the fan speed will be
turned up to the setting of the Fan Speed Count that bears the same index as the Boundary
field.
▼ CPU Smart Fan Mode = [Enabled]
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the fan speeds accordingly, the value ranging
from 0-127℃. For example, when the system temperature reaches Boundary 1 setting, the
fan speed will be turned up to the designated speed of the Fan Speed Count 1 field.
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed, the value ranging from 1-100%, 100% being full speed. The fans will oper-
ate according to the specified boundary temperatures above-mentioned.
▼ CPU Smart Fan Mode = [Disabled]
Manual PWM Setting
Set the fan speed, the value ranging from 1-100%, 100% being full speed. The fans will al-
ways operate at the specified speed regardless of gauged temperatures.
User's Manual | GH551
Advanced
X

AMD CHIPSET Setting

CPU Smart Fan Mode Se-
DRAM ECC Enable
lect
Ac Loss Control
Mini PCIE select
► GFX Configuration
► SATA Configuration Options
► SB USB Configuration
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
DRAM ECC Enable
Enable or disable the memory's Error-correcting code memory (ECC) function.
Ac Loss Control
Select between Always Off, Always On, and Last State. This field is used to specify what state
the system is set to return to when power is re-applied after a power failure (G3 state).
Always On
Always Off
Last State
Mini PCIE select
Select the signal type of the Mini PCIe channel — USB3 or PCIE.
Aptio Setup Utility - Copyright (C) 2020 American Megatrends, Inc.
Chipset
[Disable]
[Auto]
[USB3]
Version 2.20.1274. Copyright (C) 2020 American Megatrends, Inc.
The system automatically powers on after power failure.
The system enter soft-off state after power failure. Power-on signal input is
required to power up the system.
The system returns to the last state right before power failure.
Chapter 3
BIOS SETTINGS
Use this option to enable
/ disable DRAM ECC. Auto
will set ECC to enable.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
29