Connecting The Speaker Directly Using The Dedicated Audio Cable; Connecting A Second Speaker - Sony SRS-WS1 Operating Instructions Manual

Alternative ways of using the speaker
(continued)
Connecting the speaker directly using the dedicated audio
cable
You can also directly connect the speaker and another audio device using the supplied
dedicated audio cable.
1
Connect the supplied dedicated audio
cable to a device you wish to use
The auto turn off function will not work with this
condition.
Make sure that you always use the supplied
dedicated audio cable.

Connecting a second speaker

You can connect up to 2 sets of speakers to the transmitter at once. Pair the speakers
first if you are using them for the first time with this unit.
To pair the speakers again, follow the steps below.
You cannot pair the speakers with devices other than this transmitter (such as
Bluetooth devices).
1
Set the speaker to the pairing mode
Turn on the speaker, press and hold the vibration
button (for 5 seconds or longer) till the power
indicator starts flashing in yellow.
Pair the speaker near the transmitter.
2
Press the pairing button located on
the bottom of the transmitter
Press the pairing button while the power indicator
on the speaker is flashing in yellow.
When pairing is completed, the indicator stops
flashing and lights up.
Dedicated audio cable (supplied)
Power indicator
Press and hold for
5 seconds or longer.
Vibration
button
Pairing button
US
11