Brother S-7220D Instruction Manual page 46

No. Setting
range
012 0 to 500
(ms)
013 ON/OFF
014 ON/OFF
015 ON/OFF
Sewing machine motor settings (100 to 199)
No. Setting
range
100 OFF, 1 to 3
101 1 to 5
102 -10 to 10
(degrees)
103 -10 to 10
(degrees)
Default value Setting
unit
80 (ms) 10 (ms)
ON
－
ON
－
ON
－
Default value Setting
unit
OFF 1
1 1
0 (degrees) 1
0 (degrees) 1
Setting details
Delay time from standing operation pedal turning on until
motor starts operating
When AUTO function is set ON, pauses when presser
foot pedal is ON.
ON: Sewing is interrupted when presser foot lifter pedal
turns on (pause operation)
OFF: No operation
When AUTO function is set ON, motor operation can be
turned on and off by slightly depressing the high speed
pedal ON/OFF.
ON: Motor operation switches on/off each time the high-
speed pedal is depressed slightly to ON and back to OFF
OFF: Disabled (sewing machine motor does not stop)
Presser foot raising/lowering using thread trimming pedal
after thread trimming
ON: Presser foot can be raised and lowered
If memory switch No. 051 is set to "ON", thread
trimming pedal operation is disabled after the presser
foot lifter pedal has been operated during standing
operation.
(Refer to the Service Manual for details of memory
switch No. 051.)
OFF: No operation (only possible using presser foot lifter
pedal)
Setting details
Slow control after sewing start
OFF: Disabled
1: Only at the sewing start after thread trimming
2: Only when sewing is restarted
3: Always at the sewing start
Degree of slow startup immediately after sewing start
(A larger number means a slower startup)
This is not displayed when memory switch No. 100 is
set to "OFF".
Needle up stop position correction value
Needle down stop position correction value
36