Initial Instrument Functionality Check; Installation Procedure; Analyzer Information - Keysight N9030B Series Installation Note

Initial Instrument Functionality Check

1. Power on the instrument and allow the instrument to boot up, run the alignments and display
the measurement screen. The instrument will probably display a spectrum analyzer screen and
you will see the instrument sweeping.
2. There should be no alignment failures. If there are failures, investigate and fix the problem
before continuing.

Installation Procedure

Analyzer Information

1. Connect a power cord to the analyzer and turn on the analyzer.
2. After the analyzer has completed turning on, press System, Show System.
Make note of the following information from the Show System screen:
Product Number _______________
Serial Number _______________
Instrument S/W Revision _______________
3. Check for the presence of the options listed below in the Show System screen. Put a check
mark after each option listed below that appears in the show System menu.
N9030B-B2X _______________
N9030B-B5X _______________
N9030B-MPB _______________
N9030B-LNP _______________
4. Refer to the data in
the upgrade being installed:
Option FBP Upgrade
N9030BU-FBP
If the Product Number in
with the installation.
5. Refer to the data in
upgrade to version A.25.00 or later. Keysight recommends that you update to the latest
instrument software version to ensure that you have the latest defect fixes. To check the latest
instrument software version, visit the following website:
http://www.keysight.com/find/xseries_software
Installation Note N9030-90122
step 2 above. Verify that the Product Number in
Product Number (Step 2)
N9030B
step 2 is not appropriate for the Option FBP upgrade, do not proceed
step 2 above. If the instrument software is earlier than A.25.00, you must
Option FBP, Full Bypass Path
step 2 is appropriate for
5