The error message <P FAIL> indicates that the balance was disconnected
from power supply without pressing the ON/OFF button.
Remedy:
Press ON/OFF. The device will carry out a display test.
The balance is ready for weighing once the weight indication appears.
7.4.1 Initial Commissioning
In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1). During this warming
up time the balance must be connected to the power supply (mains, accumulator or
battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
7.5 Connection of peripheral devices
Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they are
ideally tuned to your balance.
ADJ-SH-e
1910
15