Cleaning The Drain Pump - Zanussi ZWD11683NS User Manual

1. Open the drawer. Press the catch downwards
as indicated in the picture and pull it out.
2. Remove the top part of the additive
compartment to aid cleaning and flush it out
under running warm water, to remove any
traces of accumulated detergent. After
cleaning, put the top part back into position.
3. Make sure that all detergent residue is removed
from the upper and lower part of the recess.
Use a small brush to clean the recess.
4. Insert the detergent drawer into the guide rails
and close it. Run the rinsing programme
1
without any clothes in the drum.
2

CLEANING THE DRAIN PUMP

WARNING! Disconnect the mains
plug from the mains socket.
Regularly check the drain pump filter
and make sure that it is clean.
Clean the drain pump if:
• The appliance does not drain the water.
• The drum does not turn.
• The appliance makes an unusual noise because
of the blockage of the drain pump.
• The display shows the alarm code
WARNING!
•
•
Proceed as follows to clean the pump:
1. Open the pump cover.
1
2. Place a suitable bowl below the drain pump
access to collect the water that flows out.
3. Open the chute downwards. Always keep a rag
nearby to dry up any water spillages when
removing the filter.
Do not remove the filter while the
appliance operates.
Do not clean the pump if the water
in the appliance is hot. Wait until
the water cools down
2
.
31