Troubleshooting - Beko BK 20 HPLCD Manual

7

Troubleshooting

If there is an error, the relevant error code will be
displayed (e.g. E01).
Resettable errors are shown with E, while non-re-
settable ones are shown with F. Press RESET (K4)
to reset the combi boiler. If the problem persists,
call the authorised service provider.
Error code Error defınıtıon
E01 Ignition failed
E02 Faulty flame formation
E03 Overheating
E04 / 05 / 06 Pressurestat error
E08 Ionisation/electronic board error
E09 Gas valve feedback error
E12 / 21 Electronic board error
E82 Ionisation error
F02 Faulty flame formation
Reset lockup (turn on/off the power
F13
supply of the appliance)
F22 Low voltage failure
F23 Pressurestat failure
F25 Electronic board error
F31 Central heating NTC sensor failure
F32 External air sensor failure
F33 Utility water NTC sensor failure
F37 Low water pressure failure
F59 Gas valve failure
Warning! If the problem persists
even if you have applied the in-
structions provided in this section,
A
please contact the dealer where
you purchased the product or the
Authorised Service Provider. Never
try to repair faulty products on your
own.
Combi Boiler / User Manual
33 / EN