Cisco IP DECT 6800 Series Hardware Installation page 12

Mount the Base Station on the Wall
• With the ceiling mount bracket: Hold the bracket over the holes and screw in the screws until the bracket
doesn't move.
Step 5
Connect the Ethernet cable to the base station and route the cable through the slot in the base station.
Step 6 Plug the power adapter into the device and route the cable through the slot in the device.
Step 7
Put the device on the wall.
• Without the ceiling mount bracket: This diagram shows the alignment of the screw heads and the device.
This diagram shows how you seat the device on the screw heads.
Hardware Installation
12
Hardware Installation