NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Slide the control-buttons board cable into the connector on the control-buttons board and close the latch to secure the cable.
NOTE:
You must correctly align the control-buttons board to ensure that it is properly secured to the display-
assembly base. For correct orientation, see step 1 in
2. Slide the control-buttons board into the slot on the display-assembly base until the securing clips lock in place.
Post-requisites
1. Replace the
back
cover.
2. Replace the stand.
38
Replacing the control-buttons board
Replacing the control-buttons board
computer. After working inside your computer, follow the instructions in
"Removing the control-buttons
19
After
board".