Easytouch Pl4/Psl4 Control System Accessories - Pentair EasyTouch PL4 User Manual

2
EasyTouch PL4/PSL4 Control System Accessories
®
QuickTouch II Wireless Controller (optional)
®
The optional hand held QuickTouch
pool/spa circuits. Each of the four functions on the remote has an on and an off
button. For more information, see page 50.
Indoor Control Panel (optional)
The EasyTouch PL4/PSL4 Indoor Control Panel provides you with one touch
automatic control for all of your pool and spa daily operations from inside your
home. The indoor control panel is connected to the Power Center enclosure.
Wireless Control Panel (optional)
The EasyTouch PL4/PSL4 Control System Wireless Controller provides complete
control of pool and spa operations from inside you home or outside around your
pool area. For more information, see page 55 and 65.
IntelliChlor Salt Chlorine Generator - (optional)
®
The optional IntelliChlor Salt Chlorine Generator system allows the EasyTouch
PL4/PSL4 Control System system to automatically control water sanitization by
using a low concentration of salt (sodium chloride) in the pool and spa water.
IntelliChlor automatically converts the salt into free chlorine which eliminate
bacteria and algae in the pool and spa water. The chlorine will then revert back to
sodium chloride after killing the bacteria. The outcome of this continuous cycle,
practically eliminates the need to use sanitizing chemicals in the pool/spa water.
IntelliChlor model IC20 (P/N 520554/520556) is designed for swimming pools up to
20,000 U.S. gallons (75,000 liters). Model IC40 (P/N 520555/520556) is designed
for swimming pools up to 40,000 U.S. gallons (151,000 liters).
IntelliChem Chemical Controller (optional)
®
The optional IntelliChem
dispenses correct amount of chlorine or bromine, muriatic acid or CO2 gas.
IntelliChem provides continual analysis of your swimming pool water sanitation
and pH levels, providing real-time status information to dispense the proper
amount of muriatic acid (pH reducer) and chlorine or bromine for the correct
sanitization and pH balance. IntelliChem Controller operates with or without a
salt chlorine generator to provide a self-replenishing supply of chlorine generated
from salt. IntelliChem Controller can also connect to carbon dioxide (CO2) liquid
gas tanks to lower pH in your swimming pool water. When CO2 dissolves into
water it produces weak neutral bicarbonate salts which reduces pH. CO2 is
environmentally friendly and produces no secondary pollution into the treated
water by salts such as chlorides or sulfates. IntelliChem also supports IntelliChlor
Salt Chlorine Generator to help manage your pool water sanitizer levels.
iS4 Spa-Side Remote (optional)
The iS4 Spa-Side remote controller is a double-insulated, waterproof device
that is UL (1563) listed for installation at the water's edge. Installed above
the water line of the spa wall, or in the deck within arm's reach of a spa
occupant. The iS4 can control four circuits from the
spa location. Used for activating spa circulation and any three auxiliary
pieces of equipment (such as lights, jet pump, air blower, etc.). The red
status LED indicator glows steady when in Spa mode and flashes while the
spa is heating. For more about assigning circuits to the iS4 buttons, refer
to "Settings Menu: iS4 Spa-Side Remote controller," on page 50. There are
two installation choices as shown.
EASYTOUCH PL4/PSL4 Control Systems User's Guide
®
II Wireless Controller can control up to four
®
Controller is a pH and ORP sensing device that
®
QuickTouch II Wireless Remote
(P/N 521245)
IntelliChlor Salt Chlorine Generator
IntelliChem Chemical Controller
®
iS4 Spa-Side Remote
(P/N 521885) Optional