in-lite CB-056/M Manual page 16

Installing fixtures on 12 V
You can easily connect in-lite fixtures to the low-voltage cable using the
Easy-Lock connector (supplied with each fixture). Important! Always
check the manual for specific instructions for the relevant fixture. See
www.in-lite.com.
Step 1
Join the Easy-Lock connector to the main cable. (Fig. 13)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-Lock
connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will cause
the contacts to be pushed through the insulation on the cable. In tight-
ening the cap, a little gel is applied to the contacts in the Easy-Lock
connector. This serves to protect the contacts against moisture. A lit-
tle gel may possibly come out of the Easy-Lock connector: so after in-
stallation (and/or before a meal), wash your hands with soap and wa-
ter, and avoid the gel coming into contact with your eyes.
Step 2
Connect the main cable to the fixture by connecting the mini-connector.
(Fig. 14)
If the lamp does not work correctly, check that the Easy-Lock connector
is properly connected to the main cable. Do the same for the mini-con-
nector. Repeat steps 1 and 2. When the fixture is connected to the main
cable also check that the contacts of the Easy-Lock connector are not
bent. If you have any problems, contact your dealer.