Module; Transporting The Device; Cleaning The Device - Fujitsu FUTRO S5010 Operating Manual

Important notes
Important notes for the preparation for use of your
device using the Power-over-Ethernet module
With the help of the Power-over-Ethernet module you can operate the device via the LAN without an
additional power supply. For this, you need to have an appropriate network infrastructure.
To operate the device using the Power-over-Ethernet module, end-span or midspan devices
as defined in IEEE 802.3at and shielded CAT-5 network cables or higher-quality cables with a
larger cross-section (AWG23 or smaller) and a maximum length of 75 m are required. End-span
devices will only be supported in connection with a hardware classification.
When operating the device using the Power-over-Ethernet module, due to the limited power
output, not all hardware expansion levels are possible. For this reason, the use of USB
port type C (S26361-F3465-E9) or of PCI-Express expansion cards is prohibited. If you
have any questions, please contact our support or sales outlet.
Depending on the system utilisation, occupancy of external interfaces (excluding the keyboard,
screen, microphone and headset) may cause overloading of the Power-over-Ethernet
module. In case of overheating or overload, the system can be shut down automatically
to prevent damage to the device or the network. In the event of switching off, the
assignment of the external interfaces must be checked or reduced.
If the system does not receive the required power according to standard 802.3 at (25.5 W), the
system stops in the post with an error message. In this case, check your midspan or end-span device.

Transporting the device

Transportation Device, Retransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.

Cleaning the device

Transportation System unit,see Device Retransportation Device,
Turn off all power and equipment switches and disconnect the power
plug from the mains outlet.
Do not clean any interior parts yourself, leave this job to a service technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic (alcohol, thinner or acetone).
Never clean the device with water! Water entering into the device could
present a serious risk to users (e.g. electric shock).
Ensure that no liquid enters the system.
The surface can be cleaned with a dry cloth. If particularly dirty, use a cloth that has been
moistened in mild domestic detergent and then carefully wrung out.
Use disinfectant wipes to clean the keyboard and the mouse.
12 Fujitsu