SAVE THESE
INSTRUCTIONS
To attach the handle
1. Remove the nut and screw from the bottom of the
handle.
2. Attach the handle onto the handlebar.
3. Align the screw hole in the handle with the screw
hole in the handlebar.
4. Put the screw into the screw hole at the bottom of
the handle and through the handlebar.
5. Attach the nut on the screw and tighten the nut.
To assemble the handlebar
1. Put the handlebar into the bracket.
2. Attach the knob but do not tighten fully.
12
Assembly
3. Adjust the handlebar to put the product in a good
operation position.
4. Tighten the knob fully.
To put the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar until it is parallel to the shaft.
3. Turn the handlebar around the shaft.
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 29 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
Accessories on
609 - 001 -