Download
Share
Print this page
Traulsen KROGER RBC100 Training Manual
  1. Manuals
  2. Brands
  3. Traulsen Manuals
  4. Chiller
  5. KROGER RBC100
  6. Training manual
Traulsen KROGER RBC100 Training Manual

Traulsen KROGER RBC100 Training Manual

Blast chillers
Hide thumbs Also See for KROGER RBC100:

Advertisement

Quick Links

Download this manual See also: Service Manual, Owner's Manual
TRAULSEN BLAST CHILLERS
Models: RBC50, RBC100 and RBC200

Advertisement

loading

Related Manuals for Traulsen KROGER RBC100

Summary of Contents for Traulsen KROGER RBC100

  • Page 1 TRAULSEN BLAST CHILLERS Models: RBC50, RBC100 and RBC200...

  • Page 2: Table Of Contents

    TRAULSEN RBC50, RBC100 & RBC200 BLAST CHILLER TRAINING GUIDE Table of Contents Programming The Control... 2 Placing Probes/Loading Pans... 3 Basic Operation... 4 Ending the Cycle/Printing... 5 Care & Cleaning... 6 Troubleshooting... 7 Press to chill BY TEMP Press to start...

  • Page 3: Programming The Control

    How to Set Correct Date & Time 1. From the Main Menu Screen press MORE, then SETUP. The display will change to the Password Screen. 2. From the Select Supervisor Screen, use the UP and DOWN arrows to the left and right of PASSWORD to select 57.

  • Page 4: Placing Probes/Loading Pans

    TRAULSEN RBC50, RBC100 & RBC200 BLAST CHILLER TRAINING GUIDE Placing Probes/Loading Pans Basic Probe Placement NOTE Using probes with small size products (like chicken strips) is not recommended. See CHILL BY TIME for correct chilling method. Probe 1 Probe 2 Probe 3 •...

  • Page 5: Basic Operation

    Starting A Chill Cycle (using EZ Start) 1. Load product into chiller. 2. Insert probe(s) and close door. 3. Press EZ START (see figure 1). NOTE: To manually start a cycle, after Step 2 press BY TEMP - select cycle type (ex.

  • Page 6: Ending The Cycle/Printing

    TRAULSEN RBC50, RBC100 & RBC200 BLAST CHILLER TRAINING GUIDE Ending The Cycle/Printing Printing PRINT PROBE #1 NONE Paper Cycle Data Printout Changing The Printer Paper fig. 1 1. Remove the control cover or open printer access door on RBC50 (see figure 1).

  • Page 7: Care & Cleaning

    Probes 1. Remove probes by turning the circular locking ring which secures these inside the chiller. 2. Wash/sanitize probes. NOTE: Probes can be immersed in water during cleaning. 3. Allow probes to air dry before replacing in chiller. Interior/Exterior 1. Disconnect power supply. 2.

  • Page 8: Troubleshooting

    Too much ice on evaporator coil. Cover product (if not already) and/or run manual defrost prior to next chill cycle. TR99999 Kroger version rev. 06/10) 4401 Blue Mound Road, Fort Worth, TX 76106 • (800) 825-8220 • www.traulsen.com © 2010 Traulsen. All rights reserved.

This manual is also suitable for:

Kroger rbc200Kroger rbc50