Table of Contents
Advertisement
Cleaning
N.B: during prolonged cooking of foods with
a high water content (e.g. pizza, vegetables,
etc.) condensation may form on the inside of
the door and around the seal. When the oven is
cold, dry the inside of the door with a cloth or
sponge.
Accessories:
•
Soak the accessories in water with washing
up detergent immediately after use, handling
them with oven gloves if still hot.
•
Food residues can be easily removed using a
washing-up brush or sponge.
•
See the "Cleaning" section for instructions on
how to clean the Artisan accessory.
Cleaning cycle of ovens with pyrolysis function
(if present):
WARNING
Do not touch the oven during the pyrolysis
–
cycle.
Keep children away from the oven during
–
the pyrolysis cycle.
Keep animals away during and after the
–
pyrolysis cycle.
Insert the cap of the cavity plug before
–
running a pyrolysis cycle.
This function burns off spatters produced inside
the oven when cooking at a temperature of
approx. 500 °C. At this high temperature, the
deposits turn into a light ash which can be easily
wiped away with a damp cloth once the oven has
cooled down.
Do not select the pyrolysis function after every
use, only when the oven is very dirty or produces
smoke or fumes while preheating or cooking.
•
If the oven is installed below a hob, make
sure that all burners or electric hotplates
are switched off during the self-cleaning
(pyrolysis) function.
•
Remove all accessories before running the
pyrolysis function (including the shelf guides).
•
For optimum cleaning of the oven door,
remove the worst soiling with a damp sponge
before using the pyrolysis function.
•
Before selecting the pyrolysis function, use
a damp sponge to remove any marks on the
round stainless steel cover of the fan (Twelix
Disc) and from the inside glass of the oven
door.
The appliance is equipped with 2 pyrolysis
functions:
1. Energy-saving cycle (PYRO EXPRESS/ECO):
which consumes approximately 25% less
energy than the standard cycle. Select it at
regular intervals (after cooking meat on 2 or 3
consecutive occasions).
2. Standard cycle (PYRO): which is suitable for
cleaning a very dirty oven.
•
In all cases, after a certain number of uses
and depending on how dirty the oven is, a
message on the oven display advises you to
run a self-cleaning cycle.
N.B: during the pyrolysis function, the oven
door will not open; it will remain locked until
the temperature inside the oven has returned
to an acceptably safe level.
Cleaning the Artisan accessory:
•
Internal electrical socket: remove the metallic
plug cover; use a damp sponge to clean the
plug. Do not use metallic and/or sharp tools.
•
After every use, allow the steam grid to cool
and then clean it, preferably while it is still
warm, to remove stubborn dirt and stains
caused by food residues (e.g. food with high
sugar content). Dishwasher safe.
•
Soak the drip tray in water with washing-up
liquid added immediately after use, handling it
with oven gloves if still hot. Food residues can
be easily removed using the brush supplied by
the After-sales Service.
Note: After a certain number of uses at high
temperatures, the heating element will naturally
change colour owing to the formation of layers
of ferrous oxide aggregates. These do not,
however, affect the functionality and safety of the
component.
Descaling:
Pour in an additional 800 ml of cold white vinegar
and top up to the "max" mark with water at room
temperature. Leave for 6-8 hours, then rinse with
water and remove any residue with a non-abrasive
sponge.
Specific products for cleaning and descaling can
be purchased separately from the After-sales
Service.
9
Advertisement
Table of Contents
